The PicoAAB from Gate is the smallest, 3rd generation MOSFET with Active Brake. You can use this MOSFET unit with batteries up to 14.8v LiPo, and can be installed in every AEG replica; even the strongest out there. All the necessary wires for installation are included, and the interface in the replica is limited only to running one or two additional wires from the contacts. Using this MOSFET allows the user to achieve a higher rate of fire and faster trigger response, while also protecting contacts from burn out. It targets the energy from the battery directly to the motor, bypassing the mechanical trigger contacts. The Active Brake greatly increases the life of your AEG gearbox by not allowing the piston to be compressed after each shot, the piston will stop in the front position which eliminates unnecessary stresses. After releasing the trigger, the rifle immediatly stops firing thus resulting in more advanced realism while saving your precious ammunition. The Digital Interface provides full compatibility with micro-switches and is fully resistant to contact bounce. The result is a bigger ROF, faster trigger response, and a lower MOSFET temperature. The integrated Electronic Fuse totally protects the MOSFET from overheating and short-circuits of the AEG electrical system while also protecting the motor and battery against damage in case the rifle becomes jammed. Many useful functions and great electrical specifications make the PicoAAB MOSFET Unit able to meet all the needs of experienced airsoft players.